Bearing Cover & Baffle (30/31/32/36) Service Kit

Extra Information

• Compatibility: Intended for the Tork Craft TCAG0230 angle grinder series.
• Clean out carbon dust and old grease before reassembly to prevent contamination being trapped inside.
• While open, inspect bearings, seals and related components for wear and replace as needed for best results.

Features

• Protective-component service kit: Replaces bearing cover and baffle components used in the TCAG0230 assembly.
• Parts reference match: Covers parts 30, 31, 32 and 36 as per the service diagram references.
• Helps reduce contamination: Supports cleaner bearing areas by improving internal shielding and separation.
• Model-specific compatibility: Intended for use with the Tork Craft TCAG0230 angle grinder.

Benefits

• Extend bearing life: Better shielding can reduce dust ingress and premature wear.
• More consistent running: Properly seated covers/baffles help prevent rubbing, vibration and heat build-up.
• Smarter servicing: Perfect when rebuilding—replacing worn covers avoids repeat strip-downs later.

Safety

• Wear eye protection and a dust mask when working with internal debris and carbon dust.
• Disconnect power before opening the tool or fitting any spare parts.
• Keep all covers and protective parts fitted correctly — missing components can lead to overheating and premature failure.
• After reassembly, confirm the guard is correctly fitted and the spindle rotates freely before use.
• Perform a no-load test run in a safe area and stop immediately if you hear rubbing, rattling or excessive vibration.

Specifications